Tips for Installing an RV Cover

*Tips and Content available from RV Cover Supply*

https://rvcoversupply.com/

Most RV Covers are rolled and packaged with the front end of the cover to
the outside and labeled.

The front of the RV cover should be labeled for easy identification (most are labeled with the logo on the front of the RV cover).Your RV Cover will provide years of service if you take the precaution of examining your RV for sharp areas that could tear the cover (such as mirrors, awning mounts, gutter extensions etc.). Taking a few moments to pad these areas before installing the cover will help extend the life of the RV cover.

To install the cover, proceed as follows:
1. Place the rolled cover on the front end of the roof.
2. Roll the RV cover to the back end of the roof.
3. Working from front to back, spread the cover to the side edges of the roof.
4. From the ground, use a stepladder and work from front to back to pull the cover
down over the sides of the RV. Adjust the fit as necessary.
5. Before securing the elasticized hems, you may wish to use the included
reinforcement/repair kit to add protection to stress areas from sharp edges and gutter spout extensions.
6. Secure the elasticized hems under the front and rear end of the RV.
7. Snug additional material using the adjustable strap system attached to the front, rear and undercarriage of the unit to provide a secure fit.
8. All covers (except Pop Up and Class B Conversion Van Covers) have attached tie down straps at the bottom sidewalls of the cover. Slide straps under the unit and connect on the opposite side.

Please Note! Your RV Cover is for storage only. Do not attempt to travel with the cover on, or partially on. Contact with hot surfaces such as exhaust systems will damage the cover. Always cover sharp areas of the RV before installing the RV cover (tennis balls or pieces of pool noodles work great).

Caution! Always take care when walking on the roof of your RV. Avoid walking on the RV Cover. Walking on the cover may cause you to slip. Whenever possible,use two people to install the RV Cover. Do not attempt to install the cover in windy conditions.

Cleaning Instructions: The cover may be cleaned by spraying with a hose and/or using a solution of mild soap and water, and a soft brush. Rinse with hose and allow to dry completely before folding for storage.

BEFORE INSTALLING COVER

Make sure the unit is clean and free of any debris and all sharp areas are covered with padded protection.

Article Provided by: https://rvcoversupply.com/

 The Importance of Having an RV Cover

Owning an RV cover comes with a range of benefits. However, these do not come so easy. Of course, the importance of protecting an RV when it is not in use cannot be overemphasized. If the RV is stored outside (i.e. directly under the sun or rain), a cover is particularly important if the RV is not in use at all, especially during the winter months.

The cost of repairing the exterior of an RV is quite substantial – whether it be just a roof repair, mere paint job or simple window treatment – chances are it will be way too costly. Undoubtedly, these repairs are definitely going to be inevitable if the RV is exposed to the elements for a long time.

In the first place, the cost of preventing that impending damage by covering the RV cannot be compared with the cost of repairing it. And if need be, this single act of prevention will go a long way in maintaining the resale value of the vehicle, as it will only require fewer exterior washes.

How to Choose the Best RV Cover

When choosing an RV cover, there are three basic factors to consider. They include size, type, and material.

Size

It is important to go for the right size of RV cover for a snug fit against the vehicle. Before shopping for an RV cover, it is needful to get the accurate measurements at hand. This can be rightly achieved by measuring the RV by hand from one end to the other while ensuring that every other thing such as the anterior storage racks, mirrors, bumpers, ladders etc. are included in the measurements.

Note: opting for a very big cover is not a good idea, as I will only make work more difficult. Also, critters will find easy access into the vehicle if the RV cover is loosely fitted. When measuring for a Travel Trailer RV Cover remember to Not include the hitch or propane tanks.

Type

There are different types of RV covers. These covers depend mainly on the type of 5th wheel RV involved. For instance, truck or travel trailer RV covers are much different than those for a Class A motorhome or Class C motorhome. Covers that match with the RV’s body style will best protect the vehicle.

Material

The choice of material for an RV cover chiefly depends on the condition of the weather in which it will be stored. However, there are RV cover manufacturers that produce a variety of materials for every kind of climate. Some of these manufacturers include - Eevelle (Expedition - Expedition S2 and Goldline), Carver Industries, and Classic Accessories (PermaPro, Polypro III and Skyshield and Encompass).

An RV cover could be the difference between a dinged door and a clean coat especially with all the external forces affecting the RV’s façade. Unlike a tarp, RV covers are made to allow for free flow of the right amount of air and to keep water off.

Article Provided by: https://rvcoversupply.com/